It is a Fluid-O-Tech pump. Stainless steel or brass housings with 3/8″ GAS or NPT ports and internal relief valves are available with the PO 70-400 series positive displacement rotary vane pumps. Nominal flow rates range between 70 and 400 l/h at 1450 rpm. In addition to 1725 rpm, this vane pump series can deliver 530 liters per hour at a maximum flow of 1725 rpm. It can discharge pressures up to 16 bar (230 psi). This series includes a coupler and adapter for mounting on M71, M80, and NEMA 56C motors.
Here are a few features of the PA3501X Rotary Vane Pump:
- Brass Housing and Rotor
- Pumping Chamber and Vanes of Graphitic Carbon
- Built-In Strainer
- Bypass Insert Class Water Pump
- Inlet And Outlet Ports Are ⅜” GAS OR NPT Threaded
- Connect To Direct Coupling Motors with A Stainless-Steel Clamp
- The maximum Operative Temperature Is 158 F
- Direct Or Magnetic Drive
- Flow Rates of Wide Range
- Pulsation free flow
- Internal relief valve available
- Long service life
- NFS and WRAS listed
Let’s see few applications of PA3501X Rotary Vane Pump:
- Beverage Vending Machines
- Post-Mix Drink Dispensers
- Espresso Coffee Machines
- Water Treatment
- Water Dispensers
- Cooling Systems
https://youtu.be/2TeESAtEBHU
How to mount the pump onto the motor?
a) An electric motor with clamp mounting (type 48YZ)
- Ensure that the motor is disconnected from the electricity.
- Attach the clamp to the pump by inserting it on the shaft side.
- Connect the pump and motor by inserting the pump shaft into the motor shaft and pushing it until it stops.
- Adjust the pump to your desired position.
- The clamp should be positioned so that it can surmount both the pump and the motor rings.
- The clamp screw should be tightened using a torque of at least 1-1.5Nm.
- Clamp the pump on the motor tightly enough so that it doesn’t rotate.
- If the pump is noisy during start-up, the clamp screw must be untightened, the pump repositioned, and the clamp screw retightened.
- Adding a 48YZ optional coupling (92-80-04) between the pump and motor will prevent the pump from being noisy.
b) An electric motor with a mounting hole in the form of either NEMA 56C or B14
- It is important to unplug the motor from the electrical system.
- Attach the coupling to the motor by mounting the motor side on the motor.
- Secure the set screw (only for couplings equipped with a set screw).
- Attach the shock absorber to the coupling on the motor side.
- Place the coupling’s pump end inside the shock absorber.
- Screw the adapter to the motor flange and tighten it.
- Secure the coupling around the pump shaft.
If you are looking to buy Fluid-O-Tech’s PA3501X Rotary Vane Pump, then NESPL is the best brand for you. NESPL is an exclusive worldwide distributor of Fluid-O-Tech.
Must Visit: https://www.natronequipments.com/
